We needed to test the motor to which I had soldered wires. My old PC had a working SMPS(switched-mode power supply). So I pulled it out of the PC and used the floppy power cable as the source. I connected two wires each into the floppy red and yellow power cable. Then I fixed these wires to the breadboard. I took the motor’s wires and completed the circuit and switched on the power supply. The motor was succesfully working, also confirming that I could use the unregulated power supply as my source.
After this my friend and I got on to testing LEDs and switches using the SMPS. We connected each component and tested it. We are planning to make a Regulated Power Supply using C program and parallel port.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment